The headers came back from the coating shop and they look great. The surface texture is slightly rough -- about the same as 240 grit sandpaper. Hopefully, they will be easy to keep clean. The headers and 2 intermediate pipes are coated.
Tuesday, January 31, 2017
Coated headers are done
Sunday, January 15, 2017
Closing up the drive side
Adapter plate, clutch, bell housing and drop gears are installed. We decided to use the flywheel as-is since I had it resurfaced in 2009, but did decide to replace the friction disk and pressure plate.
Wednesday, January 11, 2017
Monday, January 9, 2017
Wednesday, January 4, 2017
New motor mounts
I had always suspected that my motor mounts were worn. By looking at the exhaust pipe clearances, it always seemed like the engine sat just a little too low in the car. These new mounts should fix that,
Subscribe to:
Posts (Atom)
Posts
